- 324
- 675 881
66Oliver
United States
Приєднався 28 лют 2015
I’m your average grease monkey with a passion for anything antique.
"Saving the past, one piece at a time."
"Saving the past, one piece at a time."
Відео
Saving an Abandoned John Deere 300 - Will it Run After 15 Years?
Переглядів 295Місяць тому
This is one of the most surprising revivals I’ve ever done. Didn’t really have much to do besides basic maintenance and it was ready to go! 1977 John Deere 300 garden tractor with the Kohler K341AQS engine and replacement 48” mower deck. A solid machine!
Will it Run After 20 Years? Abused John Deere 316 Garden Tractor
Переглядів 774Місяць тому
This one might take the cake for being the worst tractor yet in terms of abuse! This is a 1991 John Deere 316 garden tractor with the 50” deck and well worn Onan P218G engine. Will this ole beast run again?
Reviving a JUNK John Deere 430 Diesel Garden Tractor
Переглядів 6122 місяці тому
I know the ending had a lot left to be desired since it became a parts tractor. I’ll will try to find a GT that can be properly revived at some point in time. This one was just too worn everywhere else to be worth fixing (to me at least).
How to Do a Full Service on a John Deere Compact Tractor (4720)
Переглядів 683 місяці тому
A full service minués greasing the machine and changing hydraulic oil as those have different intervals. (Daily and after every 400 hours.)
Will This Old FORGOTTEN IH Pickup Truck Run After 20 Years?
Переглядів 4293 місяці тому
Will This Old FORGOTTEN IH Pickup Truck Run After 20 Years?
Testing Hydraulic Pumps Oliver Tractors!
Переглядів 1496 місяців тому
Some expected and unexpected results.
John Deere 110/112 NOT CHARGING!
Переглядів 2356 місяців тому
Bonus of tearing the 110 engine down as well.
Buyer’s Guide - John Deere 110/112 or 200 Series
Переглядів 3247 місяців тому
Includes most items from the first John Deere 110 all the way to the 216. Includes some common implements as well.
$400 Combo: Was It Worth It? John Deere 110 and 112
Переглядів 1828 місяців тому
A deal I couldn’t pass up, but was it worth it?
How to Fix a Leaking Tire on a Lawn Mower, Car, and More!
Переглядів 1608 місяців тому
How to Fix a Leaking Tire on a Lawn Mower, Car, and More!
Dodge Durango/Dakota LED Headlight and Foglight Upgrade - Is It Worth It?
Переглядів 2739 місяців тому
Dodge Durango/Dakota LED Headlight and Foglight Upgrade - Is It Worth It?
One Step Forward and Two Steps BACK! Oliver Super 77 Fix Up - Part 3
Переглядів 19710 місяців тому
One Step Forward and Two Steps BACK! Oliver Super 77 Fix Up - Part 3
Half Century of Progress 2023 - Plowing Action!
Переглядів 44410 місяців тому
Half Century of Progress 2023 - Plowing Action!
How To Drive a Manual Transmission in 16 Minutes or Less! (My Style)
Переглядів 31911 місяців тому
How To Drive a Manual Transmission in 16 Minutes or Less! (My Style)
John Deere 212 Engine Rebuild Part 2 - Is the Kohler Worth it?
Переглядів 30211 місяців тому
John Deere 212 Engine Rebuild Part 2 - Is the Kohler Worth it?
Off with the Clothes! Oliver Super 77 Fix Up - Part 2
Переглядів 667Рік тому
Off with the Clothes! Oliver Super 77 Fix Up - Part 2
Impulse Buy of the Century! Rough Antique Oliver Super 77 Tractor
Переглядів 1,4 тис.Рік тому
Impulse Buy of the Century! Rough Antique Oliver Super 77 Tractor
Fixing Fuel Problems on Old John Deere 420 Garden Tractor
Переглядів 313Рік тому
Fixing Fuel Problems on Old John Deere 420 Garden Tractor
One Stubborn Mule! Free JUNK Craftsman Weedeater - Will It Run Again?
Переглядів 62Рік тому
One Stubborn Mule! Free JUNK Craftsman Weedeater - Will It Run Again?
FREE Abandoned 4 Stroke Weedeater - Can it Run Again?
Переглядів 115Рік тому
FREE Abandoned 4 Stroke Weedeater - Can it Run Again?
Spring Work with Antique Farm Oliver and John Deere Equipment
Переглядів 243Рік тому
Spring Work with Antique Farm Oliver and John Deere Equipment
What To Look For When Buying a John Deere 420/430!
Переглядів 11 тис.Рік тому
What To Look For When Buying a John Deere 420/430!
What to Look for When Buying an Oliver Fleetline or Super Tractor!
Переглядів 786Рік тому
What to Look for When Buying an Oliver Fleetline or Super Tractor!
2001 Ram 1500 5.2 Magnum V8 0-60 Time
Переглядів 3,1 тис.Рік тому
2001 Ram 1500 5.2 Magnum V8 0-60 Time
John Deere 212 Engine Rebuild - Part 1: What’s the Damage Doc?
Переглядів 1,7 тис.Рік тому
John Deere 212 Engine Rebuild - Part 1: What’s the Damage Doc?
What to Look For When Buying a Dodge Dakota!
Переглядів 2,7 тис.Рік тому
What to Look For When Buying a Dodge Dakota!
Damn, not even pre-glowing 😢
@@wesleyjeurissen544 nope, lol
God I love the Mopar alignment
0:44 that kinda sounds like 2816
Mine don’t read the codes on off on off on truck the other one worked but I need the codes
@@707flores22 What year is it? It should work for the 98+.
@@66Oliver yeah it’s. 98.5 2500 Cummins
hopfully this one stays around i want to see more content on this tractor
I want a couple of these that arent in good shape for a project 😈 the two i just bought are in too good of shape to do what i want lol
Nice tractor!
Solid unit great score mate..look after her and she'll run for another 20 years
I sold it last week. I have many more projects that needed funding at the moment. I will miss it though, it was a good rig.
I tried it but its not working for my 2nd gen ram 2500 1999
2nd trick worked but my check engine light is still om, but it'll come on randomly then turn off randomly
@@hyphh191same
Best video on youtube.
Let us know when you are ready to be a man. We will introduce you to the 430
But still it's a cool video and you gained a subscriber today
If a 50" deck holds the hubs straight its good... I have 2 318s both with the 50" deck one I took ⅛" plate and made a new area to bolt the hubs to because it would Ben's anytime I hit anything that thing has like 6000 hour on it , side note the hour meter had been gone since I was a little kid but ik it has a ton of hours on it because it's been in the family since new and ik how much it mowed every time
Doesn't work on 96 Dodge rams
Yes, sadly this is available for 1998 and higher vehicles.
@@66Oliver Does the second test also reset any existing codes that are present? Id like to run both tests, but dont want to clear the codes if there are some present.
@@rbljackson I don’t believe it does, but I would write down the codes before doing the second one for surety.
How you get it to spin both? I got the same truck
Limited slip rear end.
I own a 265, 314. And f 725 ❤
Do you know if a 400 deck and a 420 deck are the same ?
Similar design but I don’t think they will interchange on tractors.
@@66Oliver thanks
So what are you doing with it? Parting it out?
Yes, it is has since been parted out. I tried selling whole, and nobody bought it. I only was asking about $1,000 for it.
Hi. I know this video is a bit old but I was wondering what was done to this truck exhaust wise? I have a muffler delete on mine and it sounds similar to this but yours is significantly louder which is what I've been wanting. Thank you.
This one was stock headers to three inch pipe, all the way back to an axle dump with an 8” tip. Previous owner put on this exhaust.
@@66Oliver Thank you for such a quick response! Appreciate the info 😃
I'm curious. Why do you have so much grass? I am getting a 420 up to speed that didn't run. It didn't have any cracks or leaks and the steering is perfect. I replaced fuel lines & suction tubes, cleaned fuel tank, added electric fuel pump, changed Hyd oil & filter, replaced hydro damper, took play out of hydro linkages (hydro still jumpy), engine needs choking so I'll probably reseal the intake manifold and clean the carburetor. Battery light stays on. 2420 hours with 85-90 compression so I'll probably rebuild the engine someday. This was the only 420 I found for sale in my area so that is why I bought such a high hour unit. BTW somebody painted it flat black so I'll have to redo the paint when all is finished.
Got 67 mph out of mine 1 3/4 pully 🤣💪✌️
Why would you title the video a revival when you didnt take the time to fix it?
Because it technically WAS a revival, since it didn’t run at all, in however many years of the last two owner’s having it. A revival doesn’t mean that I have to fix it - it just means that it came back from the dead. I do have ones where I start them up and then fix them, but this one was far too gone for it to be worth it.
01 Dakota v8 owner from California. Good video sir.
You should have tried a long chain to lower the angle of pull and added rear ballast.
Great video also will hoods interchange and on the 318 not shown will that deck fit the 420. Great videos
My levers are some loose but work great but the age and hrs it's great for my uses
My hydro lever creeps when in the center so I just pull it to nutrual.
I'm looking for a 3 point hutch possibly the ruegg
Mine didn't have a belly pan but bought 8ne fast. My steering cylinder has lots of movement but works fine. I can't see any stops for steering max. I've been thinking about making a container for hydrolic fluids that won't take forever. I'd love to have a mower deck with shaft
A few years ago I bought a 420 and the guy said it was OK but the 24hp honda that was in it had carb issues so I went ahead after getting it home and tried starting it but nit much luck so I bought the carb and tried it and it ran but still issues so I pulled it and got a briggs 23hp and all is well. I replaced all fuel lines totally with tank filters then got a cab and wired that for led lights. I got a smow blade since the one he gave me didn't fit, later I bought a easy buck loader and it's great. I added a rear weight and new tractor tires and rims new. On the old 24hp honda I'm leaning it's in the area of a governor but I took a completion check and one sides low. I priced rear gearbox for a tiller and a used ones are crazy cost so I bought a gas unit to pull behind with a lx176 or lt160. Please supply the electric fuel pump you used in case my briggs goes out. It 8nly has around under 100 hours or less. Your posts are great helps a old fart learn more
I mean i dont really expect any seat to last 30 years.😂 Ok im done😂 cheers
Oh and basically I should get the 332🤔
So if missing belly pan or side panels dont buy. Got it.😂
Soft wood is still wood.🤠🤷
y'all are so dang lucky to have a truck like that. 😂👍
My dad had a 1968 1200 4x4 with a 345 and 4 speed. Bought it from the local fertilizer plant to use as a water truck. Thing that blew my mind was it had a pto coupler by the rear bumper.
Nice to see! I have a 1967 JD 4020 I use to pull a [late ‘60’s / early ‘70’s] Sidewinder S/W 84 Pull Behind. LOVE it!
I want a 8V71 2 stroke detroit but the only detroit i have right now is a 6.5
Should have side stacked it
I've had a '68 1850 gasser for about ten years now, really like it other than no float on the hydraulics. It had the head redone and sleeves and pistons at around 3600 hours or so I was told, the head has been hot tanked so probably... Great tractor, love the hefty nature of the beast, it's my snow plowing rig and it handles a 9' Bison xhd 270 blade like a champ. Fires right up at -9°F too!
Hey, I just rebuilt my TMAXX 3.3. it wasn't started for about 10 year. Engine seized. Finally took it apart. now is start. BUT It doesn't move under its weight, fast. on a stand tyres spins like crazy... any ideas? I tried pushing it closer to the gear but still. i didn't want the gears grinding.
Try tuning the carb, you might be too rich or lean and it isn’t getting enough power. That or check rolling resistance of power train, maybe something is partially seized in the transmission or drivetrain.
That's not a truck that's an automatic
My kenworth did that, but would only shut off if you unhook the pig tail from the trailer.😂
Grab stearing wheel with both hands....shake violently whilest screaming " YOU F@#$ING PILE OF SH#T" exit cab and go home...job done
Any update? Looks like the ignition is stuck
This was last year, I believe a relay was melted on if I remember right. I didn’t work on this one.
It probably needs a camshaft anyways.
Power back feeding the ingintion switch. There is a ingintion and a bat power connection in the overhead for the CB on some 579s. They may, have tied them together.
# fuck technology
#fucktechnology
I did. I have loved John Deere since I was a kid, but Oliver tractors 🚜 are just just as good 👍 😅definitely not hating on those machines.
You wanna know what the cool part is? It's a cold start and it's a john deere two hot things I like😊
No way you said that on an Oliver Chanel , respect ✊
When you start it let it idle to warm up